---

The files in this section are arranged as installation disk images and have to be downloaded individually. Click on the disk required to download a zipped image of the disk and then unzip it and save it either to a floppy disk or to a folder on a hard drive. You may install it by double-clicking on the SETUP.EXE file in the disk image of Disk 1 if all disk images are organised in folders under a common folder with specific names "disk1" ... "disk6". Please ensure that all other applications are closed before installation. If errors involving references to ISINST30 and/or OLE objects occur then you may need to halt all background tasks such as virus scanning and network drivers temporarily, even if they are in the system tray. If Active desktop is activated it should be disabled before installation. If problems still exist then reboot the PC into SAFE mode, install the software and then reboot normally afterwards.

---

disk1 | disk2 | disk3 | disk4 | disk5 | disk6

Sevice Pack 7 | Service Pack 9 | Notes | Manual

Download all disk images, including the Service Packs. Install Disks 1 to 6 normally then run the self extracting .exe file in Service Pack 7. Following this, Service Pack 9 can be installed. Both service packs must overwrite existing files in your application directory. Service Pack 7 contains all previous service packs at this revision and must be installed before running Service Pack 9 as it contains reporting components which are not inluded with Service Pack 9. Please follow the instructions in the Notes to avoid run-time problems after installation.

Note PC specification:-

Processor: Pentium 120MHz minimum, 500MHz maximum
Memory: 32MB minimum
Operating system: Windows '95 or '98 only, Windows NT, 200 and above are NOT suitable.
IEEE Interface card manufacturer: National Instruments
Types: GPIB-PCI, GPIB-TNT and variants, GPIB-PCMCIA and variants

 

The National Instruments GPIB-PCII/IIA and GPIB-USB
interface cards are unsuitable for this application.